If your home is a mix of sealed hard floors and throw rugs, the Dreame H15 Pro CarpetFlex aims to be your one-machine solution.

Spilled juice? Muddy paw prints? Weekend crumbs ground into a rug? Swap between the Hard Floor Brush (wet/dry) and Carpet Brush (dry only), and the machine does the thinking: RGB Dirt Detection raises power where floors are dirtiest, MistLock helps keep dust from puffing back into the air, and self-cleaning up to 212°F (100°C) plus hot-air drying up to 194°F (90°C) gets everything ready for next time.
Expect up to 60 minutes of runtime (Quiet mode) and roughly 3 hours to recharge. Tanks hold 0.2 gal / 780 ml (clean) and 0.18 gal / 700 ml (used), so you’re not stuck refilling after every room.
- Dual brushes for hard floors + carpets
- Dust stays down during cleaning and emptying
- Up to 212°F (100°C) self-clean + 194°F (90°C) hot-air drying
- 60-min runtime; ~3h fast charge
- Tiny or very light rugs can lift under strong suction
- Self-clean/dry cycles add a few minutes after big jobs
Cleaning Performance
- Hard floors (vacuum & mop): For everyday spills, the Hard Floor Brush continuously rinses the roller and vacuums dirty water immediately, so you’re not pushing grime around. Think sticky soda or dried sauce—make one slow pass to wet and lift, a second pass to polish. The 23,000Pa motor gives dry debris (rice, crumbs, hair) that satisfying “gone in one pass” feel.
- Carpets & rugs (vacuum only): Pop on the Carpet Brush for area rugs and wall-to-wall. Dual-texture bristles dig out grit while TangleCut™ 2.0 trims and clears hair as you go—handy if you’ve got pets. For best results, stick to rugs at least 3 mm thick and ~2-15 mm pile; anchor light mats or move them aside.
- Edges and baseboards: To avoid that little dry strip along the wall, run a slow parallel pass with the head tracking the baseboard. The seal on the Hard Floor Brush helps you pick up right to the edge without leaving a damp line.

Brushes Overview: When to Use Which
The vacuum auto-detects which head you’re using and adjusts cleaning—and later, the right self-clean routine (hot water for the Hard Floor Brush; cold wash for the Carpet Brush).
- Hard Floor Brush (wet/dry): Use on sealed wood, tile, vinyl, or laminate. The roller spins fast, stays rinsed with clean water, and a built-in scraper keeps the nap clear so it stays in contact with the floor—fewer streaks, less re-work. Avoid unsealed surfaces or volatile liquids.
-
Carpet Brush (dry only): Swap in for crumbs, hair, and dust on rugs/carpets. It lifts debris without soaking fibers.
Surface | Mess type | Brush to use | Notes |
---|---|---|---|
Sealed wood/tile | 100 ml spill | Hard Floor | Fresh-water rinse + instant pick-up; minimal film |
Tile and grout lines | Dried sauce | Hard Floor | Multiple passes, then self-clean to avoid odors |
Medium-pile rug | Crumbs/pet hair | Carpet | Strong dry pickup; TangleCut reduces wrap |
Baseboards | Debris line | Hard Floor | Parallel edge pass to minimize “dry strip” |

Smart Features You’ll Actually Use
-
MistLock suppresses airborne dust during pickup and emptying—useful for households with pets, kids, or allergies.
-
LED display surfaces battery, cleanliness, and status messages.
-
Voice prompts guide setup, brush changes, or self-cleaning.
-
RGB Dirt Detection boosts power automatically where sensors see higher soil loads.

Maneuverability & Weight
Pushing and pulling feels lighter than typical thanks to GlideWheel 2.0 with two assist modes tuned for hard floors and carpets. The body goes nearly flat (180°), so you can actually reach under sofas and toe-kicks instead of pretending. Around chair legs, the neck’s swivel helps you steer with wrist flicks rather than full-arm shoves. Carrying up stairs is balanced around the tank housing, and once it’s on the dock, it sits securely without wobble. Smart Brush Recognition also saves you from menu diving when you change heads.
Tank System & Maintenance
Capacities are 0.2 gal (780 ml) clean / 0.18 gal (700 ml) used — enough for typical whole-home sessions without constant refilling.
After vacuuming, the system rinses the brush and internal path (up to 212°F (100°C) on the Hard Floor Brush, cold wash on the Carpet Brush) and then hot-air dries the brush, pipes, and filter (up to 194°F (90°C)). Plan roughly ~5 minutes for a quick dry on the Hard Floor Brush and ~20 minutes for a thorough dry on the Carpet Brush.
How Much Can You Clean?
A 6×5,000 mAh pack targets up to 60 minutes in Quiet mode with ~3 hours fast charging. You can clean a space of roughly 3,229 ft² (≈300 m²) on a single charge under light-to-moderate soil, which aligns with the large-home use case. In heavier mess scenarios (Max mode, repeated wet passes), expect less runtime—plan to self-clean and recharge mid-day if you routinely tackle sticky spills.
What that means day-to-day:
- Studios & small apartments (<800 ft² / 75 m²): One session, then self-clean.
- Family homes (1,200–2,000 ft² / 110–185 m²): One full pass in Auto/Quiet, self-clean at the end.

Is It Noisy?
The H15 Pro CarpetFlex’s motor and pump noise are tempered by sealed fluid paths; voice prompts remain audible without being harsh. In typical daytime use, the acoustic profile is more “low-rumble” than “high-whine,” which is apartment-friendly.
Price & Value
The H15 Pro CarpetFlex’s value case rests on one-machine coverage (hard floors + carpets), hot-water self-clean, full-path hot-air drying, and MistLock air quality benefits. If you don’t need carpet dry vacuuming or hot-air drying, Dreame’s simpler wet/dry models may fit your budget better; if you want “set-and-forget” hygiene and minimal hair maintenance, this model earns its premium.
Presale Starts in Early September. Subscribe Now for Updates and Exclusive Early Bird Gifts.
Final Verdict
Buy it if:
- Your home blends sealed hard floors and area rugs, and you want quick wet pickup, strong dry carpet pickup.
- You value hygienic, low-touch maintenance and clean air while you clean.
Skip it if you only need occasional spill cleanup on hard floors and don’t need carpet dry vacuuming—lighter, simpler options may suffice.
The H15 Pro CarpetFlex’s combination of Dual Brush System, MistLock, hot-water self-clean, hot-air drying, and RGB Dirt Detection makes it a compelling “all-floors” cleaner with real everyday convenience.

FAQ
Is Dreame H15 Pro CarpetFlex worth it?
If you want one device for wet hard-floor cleaning and dry carpet vacuuming—with hot-water self-cleaning, hot-air drying, and dust suppression—it’s a strong value.
Can I use it on carpets and rugs?
Yes—for dry vacuuming with the Carpet Brush. Dreame recommends carpets at least 3 mm thick and ~2-15 mm pile; avoid very small rugs that can be lifted by suction.
Is it safe on sealed hardwood and laminate?
Yes—the Hard Floor Brush is designed for sealed surfaces and uses fresh-water rinsing plus immediate dirty-water pickup to limit streaks.
How does MistLock help with allergies?
MistLock Dust Control converts airborne dust to damp waste during cleaning and emptying, helping reduce secondary dust pollution in the room.